The Build
Test Sequence command allows you to select which Zigzag
projects from your directory you would like to make available
to the readers using the Zigzag Test application (cf.
Note). You can also set their access
privileges.
In the
window Build Test Sequence, select the Available Test(s)
one after another (these are the Zigzag projects in your project
directory as defined by theEnvironment
> Preferences command), and then transfer them to
the field Selected Test(s) by clicking on the right-pointing
arrow.
Use the left-pointing arrow to remove a test from the list of
Selected Test(s).
When the
relevant tests have been selected, you can use the two up or
down pointing arrows on the right to rearrange the order of
the tests, if desired. The order of the tests is especially
important if you have checked the box stipulating that The
reader must do the tests in the order they are presented.
When the
first two boxes are checked conjointly, the reader can redo
at will only the last test.
Note.
If no test is selected through the Tools > Build Test
Sequence, the Zigzag Test will give the following
message:
